Re: [dvd::rip] RIP Title - Read Content

[Rob Kampen <rkampen@xxxxxxxxxxxxxxxxx>]

Hi Tim,
Funny - hope its just co-incidence, I too am running on CentOS 5.2 Plus - x86_64 version that also runs mythtv. MythTV also uses transcode, although I don't use that part of it, I keep my recordings in HD (~5GB/Hr).
I know tcprobe is available, but when I look at the help, I'm lost - video is new to me and all the options and jargon don't yet make a lot of sense to me.
All I want to do, is extract two minutes out of a DVD chapter, to use as a clip for promotion of the DVD.
I have managed to rip the chapter .vob file onto my hard drive with all the DRM / encryption rubbish taken care of by using some command line program (forgotten what it was, and not in front of the machine to check), I was hoping to use DVD:RIP to assist me with the transcode bit and extraction bit.....
All getting too hard, maybe I'll look around for some other solutions.
Kind regards
Rob


Tim Hudoba wrote:

Rob,

I have run into the same thing.  So far I have not received any
assistance.  If you hear anything please let me know what you find out.

I have gone as far as re-installing my OS (centos 5.2), down-reving
dvd::rip and it's dependencies, using 3 different dvdrom drives, and
reading the vtoc without lsdvd.  All with no success.

I agree with you though, I believe it has something to do with tcprobe
(which is bundled with transcode).  I guess there is a forum for
transcode but I have yet to look into it.

Just out of curiosity, what flavor of linux are you using?

On Wed, 2008-08-20 at 09:18 -0400, Rob Kampen wrote:
  

I have a new install of dvd:rip that appears to be complete and intact,
however when I load a DVD and select the RIP Title tab and then press
the "Read DVD table of contents" button I get the following in the log
Wed Aug 20 00:50:13 2008 Start job 'Read TOC (lsdvd|tcprobe)'
Wed Aug 20 00:50:13 2008 Start job 'Read TOC (lsdvd)'
Wed Aug 20 00:50:13 2008 Executing command: execflow lsdvd -a -n -c -s
-v -Op  2>/dev/null && echo EXECFLOW_OK
nothing else and it stalls
The job plan and progress window shows
Read TOC (lsdvd|tcprobe) 0.00% finished
    Read TOC (lsdvd)      0.00%, elapsed 15:22
    Read TOC (tcprobe)   Waiting
       Determine number of titles Waiting

I try the lsdvd command in a terminal and it works fine
I suspect that it is the tcprobe that fails, but I do not know the
syntax or what I'm looking for

some pointers as to where to look next??
I am probably missing something obvious......
Thanks and kind regards
Rob



    

--
This message has been scanned for viruses and
dangerous content by OpenProtect, and is
believed to be clean.

rkampen.vcf
Description: Vcard